# I can’t normally open a volume in 3D Slicer scanned with a Morita CT scanner

**URL:** <https://discourse.slicer.org/t/i-can-t-normally-open-a-volume-in-3d-slicer-scanned-with-a-morita-ct-scanner/32429>\
**Category:** Support\
**Created:** [October 26, 2023, 5:55pm UTC](https://discourse.slicer.org/t/i-can-t-normally-open-a-volume-in-3d-slicer-scanned-with-a-morita-ct-scanner/32429 "2023-10-26T17:55:23Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![cepcep](https://sea2.discourse-cdn.com/flex002/user_avatar/discourse.slicer.org/cepcep/32/6389_2.png) [@cepcep](https://discourse.slicer.org/u/cepcep)\
**Post date:** [October 26, 2023, 5:55pm UTC](https://discourse.slicer.org/t/i-can-t-normally-open-a-volume-in-3d-slicer-scanned-with-a-morita-ct-scanner/32429/1 "2023-10-26T17:55:23Z")

</div>

I saw your recommendation from 2017 to open Morita volumes using an nhdr file

> [@Load vol file into 3D Slicer from Morita machine](https://discourse.slicer.org/t/load-vol-file-into-3d-slicer-from-morita-machine/4815/4):
>
> I’m not sure it’s the same file type (.vol may be an overused file extension) but here’s some code to read a .vol file from a microCT machine:

Next, in my .vol file i saw min and max XYZ and summed them up. Getting three numbers 643,704,704 for “sizes:”  
But although 3D SLicer began to open up my .vol file. There was an insoluble problem “scan lines with distortion”

> **[Morita](https://disk.yandex.ru/d/V6pf6jEuV-KcRg)**
>
> Посмотреть и скачать с Яндекс Диска

 ![2023-10-26_23-51-35](https://us1.discourse-cdn.com/flex002/uploads/slicer/original/3X/0/f/0f9a738972bd68fc1ecbb62c2c67c1f9091a7d5c.jpeg)