About different versions of PRISM Rendering

[qiqi5210 (Mary)]

Hello，everyone！
I have a problem using the PRISM Rendering in the software version 2022-02-05, as shown in the following figure

I operate according to the sequence in the figure. When initializing the center, the volume rendering ROI in the fifth place in the figure appears instead of the endpoints of the previous version

What can I do to achieve the following results

I hope someone can help me. Thank you very much！

Best wishes, Mary

[pieper (Steve Pieper (Isomics, Inc.))]

Yes, this was reported recently. Apparently there’s nobody on the prism team able to work on it yet for the current version of Slicer so the older version must be used.

In the latest version of the software, the prism rendering module cannot be used normally,。

In the latest version of the software, the prism rendering module cannot be used normally, and the mouse pattern of ROI appears when points should be added. As shown in the following picture, after clicking the “initialize center” button, the ROI icon appears. [f6bac8bf6c2c8b71ea490e826463d61]