Create new cfg error RadRenderer

Community SlicerAutoscoperM
1

Hello,

I am trying to create a new .cfg file. I launch Autoscoper, click ‘new file’, add the calibration files, radiographs (), and partial volumes. When I click ‘OK’ Autoscoper shuts down and the following error gets spit out into the Slicer console: “RadRenderer::rad(): Unsupported bit depth 12”.

I also tried creating a configuration file by scratch by taking one I knew worked and changing the information using notepad, but I get the same error when trying to load the .cfg file.

I am currently troubleshooting through trial and error but I thought perhaps someone might have seen this before and know what the problem is (and what I should be looking to fix)! Maybe something to do with the bit depth of my radiographs?

Thanks!

2

Hi Jeff,

We have run into this issue as well. Currently, SAM cannot read in higher bit depth images. Can you reduce the bit-depth to 8-bit and try creating/loading the .cfg file again?

Thanks!

John

3

Yes, that worked perfectly, thank you!

1 Like