SlicerDMRI not building on metroplex/linux

Development
1

@jcfr @Sam_Horvath our SlicerDMRI extension is not building on linux (metroplex) since 2018-10-05. Can you investigate please? There is no entry at all on the dashboard for the next days (but it is building on vasstbuild). Thanks.

2

Thanks for the note. I will have a look this afternoon.

1 Like
3

Considering that we lost power in our NC office, I will have a look later tomorrow.

4

OMG, the hurricane? Hope it’s not too bad there.

5

To follow up, @ihnorton reported earlier that the extension was built during the last cycle.

6

Did not build again last night.

7

I started the night later … It is probably a matter of time.

8

It is available now (~1hr after your last message). See http://slicer.cdash.org/index.php?project=SlicerPreview&filtercount=2&showfilters=1&filtercombine=and&field1=buildname&compare1=63&value1=DMRI&field2=site&compare2=63&value2=metroplex

1 Like