Gantry tilt correction in CT DICOMS

Support
3

Hi Andras,

I had enabled that before I attempted to load the DICOM images. I followed your comment here.

  1. When I load my images through the “DCM” module, I cannot even see my image volumes. I am not sure why this is happening? But this creates a transform which allows me to go to ‘Transform Hierarchy > Harden Transform’
  2. When I load it through “Data” module, I see the image volumes, but the view is not corrected. And this does not create a transform.
    Please see below - the following image was obtained at a gantry tilt of +21.5 degrees.
    image
    image1151×862 103 KB

Please advise!