Stl The extracted file does not run

Operating system: windows 7
Slicer version: 4.9.0
Expected behavior:
Actual behavior:


20180604_113139

I set up the area to extract stl as shown in the figure above.
Then the exported stl file will not open. I am using 3Shape 3Dviewer.
“Please close all open features before deleting.” It will not run because of error window.
Please let me know what I did wrong.

Can you successfully open the STL file in other software, such as MeshLab, MeshMixer, Paraview, Blender, etc.?

1 Like

Fine. I found a way. Thank you.

What was the solution? Did you figure out what was the problem? It is important to share these details if it is an issue that others may run into as well.

1 Like

Viewer file installation is invalid. Loaded successfully from another program.

1 Like