smrolfe
(Sara Rolfe)
October 9, 2018, 7:57pm
1
Hello Slicer Developers,
I would like to tackle some improvements to the markups module. This was discussed in the thread:
https://discourse.slicer.org/t/a-users-proposal-for-markups-module-enhancements/
Before I jump in I would like to see if anyone has been working in this area or has other feedback. The issues I’d like to address first are:
○ Landmarks sticking and sliding on surface
○ One click 3D angle, length measurements from LMs.
○ SA/Volume measurements through segment editor.
○ Read a template for LM names, sequence
○ Fine control for LM placement
Thanks!
danagood
(Dana Good)
October 9, 2018, 8:30pm
2
Sara, apologies for off-topic, but I can’t see a DM option. Were you at NeuroVista? If so, quite a coincidence to see you here!
Dana
1 Like
pieper
(Steve Pieper (Isomics, Inc.))
October 9, 2018, 9:05pm
3
@danagood small hint: click on Sara’s name and there’s a message button
@smrolfe this is great to hear! I’m sure @lassoan will chime in. It might be time to start a labs page to keep notes.
1 Like
smrolfe
(Sara Rolfe)
October 9, 2018, 10:36pm
4
Thanks @pieper , I’ve created a new labs page, Improving Markups to start documenting this.
1 Like
muratmaga
(Murat Maga)
October 10, 2018, 3:33am
5
Great. I made some changes and additions to it as well.
1 Like
lassoan
(Andras Lasso)
October 10, 2018, 4:30am
6
These are all good features to develop. I don’t think any of these features are implemented.
I have design ideas for some of them, so if you decide to start working on one then start a discussion here (or in a new topic).
3 Likes